Prusa3D Forum

Notifications

Clear all

Guytranspo

Groupe: Enregistré

A(ont) rejoint: 2017/02/15

Active Member

	With the help of Prusa support, the problem seems to be solv... Dans le forum How do I print this? (Printing help)	il y a 6 years
	3DXTech Glass filled Nylon Dans le forum How do I print this? (Printing help)	il y a 6 years
	Looks like a belt or drive gear issue. Torque the gear set ... Dans le forum How do I print this? (Printing help)	il y a 6 years
	More images. Dans le forum How do I print this? (Printing help)	il y a 6 years
	Here are some images. They are from different prints. Ther... Dans le forum How do I print this? (Printing help)	il y a 6 years
	A single offset doesn't really explain much since others can... Dans le forum How do I print this? (Printing help)	il y a 6 years
	A photo of the failed print goes a long way in describing th... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Layer Shifting Problem Dans le forum How do I print this? (Printing help)	il y a 6 years
	Large x-axis shift during long print, help? Dans le forum How do I print this? (Printing help)	il y a 6 years
	Extruder part deformation. Dans le forum Hardware, firmware and software help	il y a 6 years
	Thanks again for the reply. I'll use the the start code for... Dans le forum Others (Archive)	il y a 6 years
	koder, Thank you very much for the Start g-code. I was ver... Dans le forum Others (Archive)	il y a 6 years
	Sometimes you need to use pure acetone to refresh the pei. ... Dans le forum Others (Archive)	il y a 7 years
	Bed Adhesion Starting to Fail Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

559 Forums

62.8 K Sujets

442.5 K Messages

20 En-ligne

67.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé