Prusa3D Forum

Notifications

Clear all

GuusK

Skupina: Registrovaný

Přidal se: 2019/12/04

Active Member

	Loading LW -PLA choise in Prusa Mk3.5 In forum How do I print this? (Printing help)	před 4 months
	The red part printed with my old MK3S (super quality) and th... In forum How do I print this? (Printing help)	před 5 months
	LW PLA planeprint files and other RC Planes In forum How do I print this? (Printing help)	před 5 months
	Yes only the message stay on during the hole print In forum General software discussion	před 3 years
	Prints fine but got this message when printing In forum General software discussion	před 3 years
	Purge extruder message. What to do ? In forum General software discussion	před 3 years
	Thin wall printing support in prusaslicer In forum General discussion, announcements and releases	před 4 years
	Found the solution here Place under the sensor problem solv... In forum Hardware, firmware and software help	před 4 years
	Filament sensor always 1 In forum Hardware, firmware and software help	před 4 years
	Thanks 🙂 this is the solution Now I am looking for wall ... In forum PrusaSlicer	před 5 years
	how can I remove top and lower infill density ?? In forum PrusaSlicer	před 5 years
	What is going wrong ? December now and I don't see any shipp... In forum General discussion, announcements and releases	před 5 years

Fórum Statistiky

559 Fóra

63.1 K Témata

443.7 K Příspěvky

19 Online

68 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed