Prusa3D Forum

Notifications

Clear all

Gur Telem

Groupe: Enregistré

A(ont) rejoint: 2025/02/27

Active Member

	Thanks for the answer abiut the cold bed. Already have a no... Dans le forum How do I print this? (Printing help)	il y a 6 months
	Look at this beautiful thing (the bottom obviously). Yes I s... Dans le forum How do I print this? (Printing help)	il y a 6 months
	Omg. I'm so excited I can't even wait the 5 minutes to share... Dans le forum How do I print this? (Printing help)	il y a 6 months
	My guess for why this may happen is if the nozzle is worn at... Dans le forum How do I print this? (Printing help)	il y a 6 months
	I made sure the hotend is seated properly I believe. I loose... Dans le forum How do I print this? (Printing help)	il y a 6 months
	I think I sent the wrong file then 😅.I thought maybe the bed... Dans le forum How do I print this? (Printing help)	il y a 6 months
	So, I've tried what you told me. Your build sheet is still d... Dans le forum How do I print this? (Printing help)	il y a 6 months
	Here's a coin I was trying to print. It has a ton of surface... Dans le forum How do I print this? (Printing help)	il y a 6 months
	That's a print of a 2cm diameter tube that got disconnected ... Dans le forum How do I print this? (Printing help)	il y a 6 months
	I tried that. Washed and dried. Still the same result. At ar... Dans le forum How do I print this? (Printing help)	il y a 6 months
	MK4 - No bed adhesion no matter what I do Dans le forum How do I print this? (Printing help)	il y a 6 months

Statistiques du forum

585 Forums

67.9 K Sujets

476.2 K Messages

10 En-ligne

75.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé