GunnerP – Activité – Prusa3D Forum

Notifications

Clear all

GunnerP

Groupe: Enregistré

A(ont) rejoint: 2017/03/30

Eminent Member

	I would try reducing the speed if you are still printing at ... Dans le forum Print tips (Archive)	il y a 7 years
	I have confirmed that the issue is not the filament, a new s... Dans le forum Print tips (Archive)	il y a 7 years
	I've printed a part sliced with all three versions and they ... Dans le forum Print tips (Archive)	il y a 7 years
	Layer heights have remained the same and thanks for the othe... Dans le forum Print tips (Archive)	il y a 7 years
	I just ordered some nozzle cleaning filament yesterday to tr... Dans le forum Print tips (Archive)	il y a 7 years
	Hi Martin, the red you see on the preview screen indicates i... Dans le forum Print tips (Archive)	il y a 7 years
	A late reply is better than no reply. 😉 Perimeters and top... Dans le forum Print tips (Archive)	il y a 7 years
	This looks like it might be caused by where the printer star... Dans le forum Print tips (Archive)	il y a 7 years
	What type of part is this that you are testing the strength ... Dans le forum Print tips (Archive)	il y a 7 years
	Most likely this is happening because the Prusa Slic3r autom... Dans le forum Print tips (Archive)	il y a 7 years
	I've had good results in eliminating this by turning off the... Dans le forum Print tips (Archive)	il y a 7 years
	Here is a better comparison picture of the issue. I have use... Dans le forum Print tips (Archive)	il y a 7 years
	Welcome Michael, I do use the part cooling fan while printin... Dans le forum Print tips (Archive)	il y a 7 years
	Thanks for the advice, I dried the filament in the oven yest... Dans le forum Print tips (Archive)	il y a 7 years
	Yes, they were both printed at 80C/240C with the all the sam... Dans le forum Print tips (Archive)	il y a 7 years
	Semi-transparent PETG changed after drying Dans le forum Print tips (Archive)	il y a 7 years
	What are your filament settings? i.e. extrusion multiplier, ... Dans le forum Print tips (Archive)	il y a 7 years
	Downloading the latest version of Prusa Slic3r (1.36.2) shou... Dans le forum Print tips (Archive)	il y a 7 years
	So I decided to just test and see if the layer height made a... Dans le forum Print tips (Archive)	il y a 7 years
	Same cooling and speed except I have fan disabled for first ... Dans le forum Print tips (Archive)	il y a 7 years

Page 2 / 3 Précédent Suivant

Statistiques du forum

565 Forums

64.1 K Sujets

448.8 K Messages

20 En-ligne

70.1 K Membres

Le dernier des messages: SlicerPi, Slicer Docker? Notre nouveau membre: Heiko910 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé