Notifications
Clear all
Gritz
Skupina: Registrovaný
Přidal se: 2016/07/10
Active Member
1
|
Solved (I hope so) on my MK3, rising nozzle temp to 230° and... In forum How do I print this? (Printing help) |
před 6 years | |
|
Hi everyone, similar issue here.
I tried to print D.Va's pis... In forum How do I print this? (Printing help) |
před 6 years | |
|
Confirmed, PINDA is damaged. Does anyone know where I can bu... In forum Others (Archive) |
před 7 years | |
|
Ok, factory reset did nothing.
I tried G80 command, and the ... In forum Others (Archive) |
před 7 years | |
|
Hmmm...
A few things to try.
1) Check PINDA height.
2) D... In forum Others (Archive) |
před 7 years | |
|
Z calibration doesn't check 6/9 points In forum Others (Archive) |
před 7 years |