Notifications
Clear all
Grendelrt
Grendelrt
Group: Registered
Joined: 2020/09/05
Eminent Member
2
Final update, took everything apart made sure nothing was im...

In forum Hardware, firmware and software help

3 years ago
@bobstro Crap so still not fixed. I put the new PTFE tube in...

In forum Hardware, firmware and software help

3 years ago
@bobstro pulled the PTFE tube finally out, the filament is f...

In forum Hardware, firmware and software help

3 years ago
@bobstro Yeah I have tried pushing from the top and bottom a...

In forum Hardware, firmware and software help

3 years ago
@bobstro The filament looks fine going into the top of the P...

In forum Hardware, firmware and software help

3 years ago
Stuck Filament, need some next steps

In forum Hardware, firmware and software help

3 years ago
No support material interface , is this normal?

In forum PrusaSlicer

4 years ago
Perfect, that's how it seemed to me, so I just removed the c...

In forum Hardware, firmware and software help

4 years ago
Does the nozzle setting on the printer matter?

In forum Hardware, firmware and software help

4 years ago
Thanks for the reply! I like your 2 layer thought process =)

In forum General discussion, announcements and releases

4 years ago
Thanks, do you have a default Z hop you keep as a starting p...

In forum General discussion, announcements and releases

4 years ago
Z-Hop and retraction settings question

In forum General discussion, announcements and releases

4 years ago
@tim-m30 Thanks, I tried scrubbing the printed part with som...

In forum General discussion, announcements and releases

4 years ago
Shadows on PEI Sheet showing up in first layer of print

In forum General discussion, announcements and releases

4 years ago
setting xy to .1 seems to have fixed it, thanks!!

In forum PrusaSlicer

4 years ago
@neophyl Thanks! I am using a .25 nozzle already, my minis h...

In forum PrusaSlicer

4 years ago
Loosing structure after slicing

In forum PrusaSlicer

4 years ago
Are you using a in lb torque wrench by change or just doing ...

In forum Hardware, firmware and software help

4 years ago
Thanks! I figured it was probably not critical, just somethi...

In forum Hardware, firmware and software help

4 years ago
E3D Nozzle Swap - PRUSA Instructions vs E3D

In forum Hardware, firmware and software help

4 years ago
Page 1 / 2
Share: