Prusa3D Forum

Notifications

Clear all

Giuseppe Picazio

Skupina: Registrovaný

Přidal se: 2016/07/23

Active Member

	Heatbed Burn after 3/4h of print In forum Others (Archive)	před 8 years
	Heatbed Burn after 3/4h of print In forum Others (Archive)	před 8 years
	Yes, the problem was the baud rate. Now all work properly. ... In forum Print tips (Archive)	před 9 years
	Update: after some minutes, appare this error: "Timeout Conn... In forum Print tips (Archive)	před 9 years
	Rpetier Host In forum Print tips (Archive)	před 9 years
	Ok, thank you. How I can unstick the old one from my bed? In forum Prusa i3 kit (Archive)	před 10 years
	Damage to the Bed In forum Prusa i3 kit (Archive)	před 10 years
	I have solved . The problem was in my PINDA that give the c... In forum Prusa i3 kit (Archive)	před 10 years
	But if the PINDA will be 1mm to hight of the nozle, during t... In forum Prusa i3 kit (Archive)	před 10 years
	The problem is that (seems to me) when I use the "live adjus... In forum Prusa i3 kit (Archive)	před 10 years
	PINDA Calibration In forum Prusa i3 kit (Archive)	před 10 years
	I have solved. The problem was the connection of the coolin... In forum Prusa i3 kit (Archive)	před 10 years
	Problem with extruder In forum Prusa i3 kit (Archive)	před 10 years

Fórum Statistiky

595 Fóra

70.6 K Témata

494.9 K Příspěvky

17 Online

82.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed