Prusa3D Forum

Notifications

Clear all

giuseppe.p

Skupina: Registrovaný

Přidal se: 2016/07/23

Active Member

	Heatbed Burn after 3/4h of print In forum Others (Archive)	před 7 years
	Heatbed Burn after 3/4h of print In forum Others (Archive)	před 7 years
	Yes, the problem was the baud rate. Now all work properly. ... In forum Print tips (Archive)	před 8 years
	Update: after some minutes, appare this error: "Timeout Conn... In forum Print tips (Archive)	před 8 years
	Rpetier Host In forum Print tips (Archive)	před 8 years
	Ok, thank you. How I can unstick the old one from my bed? In forum Prusa i3 kit (Archive)	před 9 years
	Damage to the Bed In forum Prusa i3 kit (Archive)	před 9 years
	I have solved . The problem was in my PINDA that give the c... In forum Prusa i3 kit (Archive)	před 9 years
	But if the PINDA will be 1mm to hight of the nozle, during t... In forum Prusa i3 kit (Archive)	před 9 years
	The problem is that (seems to me) when I use the "live adjus... In forum Prusa i3 kit (Archive)	před 9 years
	PINDA Calibration In forum Prusa i3 kit (Archive)	před 9 years
	I have solved. The problem was the connection of the coolin... In forum Prusa i3 kit (Archive)	před 9 years
	Problem with extruder In forum Prusa i3 kit (Archive)	před 9 years

Fórum Statistiky

565 Fóra

64.6 K Témata

452.2 K Příspěvky

24 Online

71.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed