Avisos
Vaciar todo
Gilles buildmaster
Grupo: Registrado
Registrado: 2024/01/01
Active Member
1
| OK, this is really odd. I had a 100% failure rate on my 2T X... | hace 4 months | |
| Same here, literally every print I start fails on nozzle cle... | hace 4 months | |
| Because it does not have a proper enclosure and dry box (fro... | hace 4 months | |
|
Yup, same here. I did not have a single print that did not f... En el foro Hardware, firmware and software help |
hace 4 months | |
|
Same here. About 50-50 chance that it gives this error at th... En el foro Hardware, firmware and software help |
hace 1 year | |
| Well good news, after running several hours with print bed a... | hace 2 years | |
| Just because you made me curious, I put a temperature sensor... | hace 2 years | |
| If you want something cheap and easy; I am using this: | hace 2 years | |
| Cheap and fast enclosure Prusa XL | hace 2 years | |
|
I noticed the same thing. I can tune the temperature of the ... En el foro Hardware, firmware and software help |
hace 2 years |