Prusa3D Forum

Notifications

Clear all

giannis.f

Group: Registered

Joined: 2016/06/17

Active Member

	X Y steps In forum Hardware, firmware and software help	5 years ago
	Hi Joan, Thank you for your reply 🙂 I checked the hotend... In forum Hardware, firmware and software help	6 years ago
	Cannot find the reasons of clogging In forum Hardware, firmware and software help	6 years ago
	Infill is visible on the outer perimeter CURA In forum Hardware, firmware and software help	7 years ago
	0.025? wow thats huge difference! I will try to lower the no... In forum Print tips (Archive)	8 years ago
	I think that my Z live adjust is fine. If I lower more the n... In forum Print tips (Archive)	8 years ago
	Hello Peter thank you for the try! Also I am very sorry for ... In forum Print tips (Archive)	8 years ago
	Hey Peter of course I can. Here you are Christophe I thin... In forum Print tips (Archive)	8 years ago
	Hey Nicholas So if i print with 55 degrees things will be be... In forum Print tips (Archive)	8 years ago
	Hey Peter, did that too. I tried IPA and Acetone but none wo... In forum Print tips (Archive)	8 years ago
	Hey Peter thanks for your reply. I have tried a big part wit... In forum Print tips (Archive)	8 years ago
	Big problem with Warping - PLA In forum Print tips (Archive)	8 years ago

Forum Statistics

559 Forums

62.9 K Topics

443 K Posts

18 Online

67.7 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed