|
Is there any reason why you didn't go for first layer height... In forum Print tips (Archive) |
před 9 years |
|
S3D First Layer Setting In forum Print tips (Archive) |
před 9 years |
|
Hi Mike
Check this out : In forum Others (Archive) |
před 9 years |
|
As i understand the live-z is that it needs to be saved if y... In forum Others (Archive) |
před 9 years |
|
And here : In forum Prusa i3 kit (Archive) |
před 9 years |
|
Hi Aaron
It is possible in S3D.
Have a look at Makers Muse ... In forum Others (Archive) |
před 9 years |
|
Can confirm, 3.0.11 dosent fix it.
Thanks Peter, i came ar... In forum Software (Archive) |
před 9 years |
|
Faulty firmware - it happens when not printing from SD card ... In forum Software (Archive) |
před 9 years |
|
Thanks Carsten
M117 i get, just a message, right ?
What is... In forum Software (Archive) |
před 9 years |
|
Hi Jared
I suppose you use the correct temp settings for AB... In forum Others (Archive) |
před 9 years |
|
Octoprint Scripts In forum Software (Archive) |
před 9 years |
|
Thanks Peter, i will check those out.
Btw, im getting a test... In forum Print tips (Archive) |
před 9 years |
|
European filament In forum Print tips (Archive) |
před 9 years |
|
Hi Thomas
I do not know why your PC dont see the SD card bu... In forum Prusa i3 kit (Archive) |
před 9 years |
|
As long as the first layer is 0.15mm or greater, there is no... In forum Print tips (Archive) |
před 9 years |
|
Is there a special reason for you to have the first layer at... In forum Print tips (Archive) |
před 9 years |
|
So, Gert, are you suggesting that Jeff and I are both "has-b... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Hmm, im no expert, i leave that to JeffJordan and PJR.
It se... In forum Prusa i3 kit (Archive) |
před 9 years |
|
If everything else fails maybe these could be an option.
D... In forum Others (Archive) |
před 9 years |
|
Really dont care, i can pay the cost if I need. Just happy t... In forum Others (Archive) |
před 9 years |
