|
module arrived yesterday. switched them out last nite and we... In forum General discussion, announcements and releases |
před 9 months |
|
I checked the screws holding the motor on the x axis but lef... In forum General discussion, announcements and releases |
před 9 months |
|
Well I spent an hour or so with tech support. tried a bunch ... In forum General discussion, announcements and releases |
před 9 months |
|
Yes it was the kit. I started using it in Dec. I don't use i... In forum General discussion, announcements and releases |
před 9 months |
|
ordered an mmu. In forum PrusaSlicer |
před 9 months |
|
I think I'm tracking but when I get lost I'll be back. lol In forum PrusaSlicer |
před 9 months |
|
tks. I will look in to that. In forum PrusaSlicer |
před 9 months |
|
I only have 1 extruder. this is what I'm referring to.
Sa... In forum PrusaSlicer |
před 9 months |
|
nut and bolt check In forum General discussion, announcements and releases |
před 9 months |
|
deselecting parts of a layer In forum PrusaSlicer |
před 9 months |
|
tried it with no spaces and didn't work. off to tech support... In forum General discussion, announcements and releases |
před 10 months |
|
pretty sure I warned everyone.. 😜 I discovered the issue too... In forum General discussion, announcements and releases |
před 10 months |
|
tks for the help..I'm going to go thru the steps one more ti... In forum General discussion, announcements and releases |
před 10 months |
|
yes a few times. I enter the info, put the thumb drive in th... In forum General discussion, announcements and releases |
před 10 months |
|
hooking my printer up to wi-fi In forum General discussion, announcements and releases |
před 10 months |
|
😮 😮 😮
just wow...that is incredible.
I say this after l... In forum Awesome prints (Hall Of Fame) |
před 10 months |
|
😆 I told you I struggle. In forum General discussion, announcements and releases |
před 10 months |
|
I saved it in inkscape as a plain svg... I knew I was doing ... In forum General discussion, announcements and releases |
před 10 months |
|
I converted it to a microsoft edge html (svg) file and fusio... In forum General discussion, announcements and releases |
před 10 months |
|
tks. I'm aiming for as much silhouette as I can get. Making ... In forum General discussion, announcements and releases |
před 10 months |
