Notifications
Clear all
Georg Müller
Groupe: Enregistré
A(ont) rejoint: 2021/02/24
Active Member
1
|
Yes I had the same screens. My Prusa was delivered November ... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
Now I installed version 3.9.2 and everything works. If I hav... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
Also a factory reset did not help. I also had to wait for ab... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
I did the update again and then tried to change the language... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
This video shows the problem Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
After update to firmware 3.9.3 printer stops after choosing ... Dans le forum Hardware, firmware and software help |
il y a 5 years |