Aktivität
 
Benachrichtigungen
Alles löschen
Gauge
Gauge
Gruppe: Registriert
Beigetreten: 2017/12/05
Eminent Member
2
It looks like you need to lower your Z adjust ever so slight...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
Hello there! You can see in that guide I posted how to do i...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
I know it's been a long time, but I put this on hold for rea...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
I just want to say, I got a bad unit. It would not auto lev...

Im Forum User mods - OctoPrint, enclosures, nozzles, ...

Vor 3 years
So, an update on this. Firstly, the return process for Prus...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
I worked with support for 4 hours, the front and back of my ...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
I sent support an email. We'll see where it goes.

Im Forum Assembly and first prints troubleshooting

Vor 3 years
Well, the paper towel was a dumb Idea because the pinda prob...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
@cwbullet I can't go lower. It's hard to see in the photo, ...

Im Forum Assembly and first prints troubleshooting

Vor 3 years
It doesn't. For those of us with Mini+ that don't level cor...

Im Forum Hardware, firmware and software help

Vor 3 years
Bed leveling fails

Im Forum Assembly and first prints troubleshooting

Vor 3 years
I can help you, what color would you like? Also what materi...

Im Forum Prusa i3 kit (Archive)

Vor 7 years
Whelp, I think I have finally resolved this, and it was a hu...

Im Forum Others (Archive)

Vor 7 years
Thanks for your reply. I tried doing bed level correction, ...

Im Forum Others (Archive)

Vor 7 years
Did the above test and results were not good. If I back the...

Im Forum Others (Archive)

Vor 7 years
Does this have the live Z gcode command at the start of the ...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
I'm going to grab some better alcohol at the store today, wh...

Im Forum Others (Archive)

Vor 7 years
Top is pretty smooth TBH. The issue with live z is, if I go...

Im Forum Others (Archive)

Vor 7 years
Help with inconsistent first layer and curling

Im Forum Others (Archive)

Vor 7 years
Try this. Don't know if I have taken enough off, and it is ...

Im Forum Improvements (Archive)

Vor 7 years
Seite 1 / 2
Teilen: