Notifications
Clear all
Gauge
Gauge
Skupina: Registrovaný
Přidal se: 2017/12/05
Eminent Member
2
It looks like you need to lower your Z adjust ever so slight...

In forum Assembly and first prints troubleshooting

před 3 years
Hello there! You can see in that guide I posted how to do i...

In forum Assembly and first prints troubleshooting

před 3 years
I know it's been a long time, but I put this on hold for rea...

In forum Assembly and first prints troubleshooting

před 3 years
I just want to say, I got a bad unit. It would not auto lev...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 3 years
So, an update on this. Firstly, the return process for Prus...

In forum Assembly and first prints troubleshooting

před 3 years
I worked with support for 4 hours, the front and back of my ...

In forum Assembly and first prints troubleshooting

před 3 years
I sent support an email. We'll see where it goes.

In forum Assembly and first prints troubleshooting

před 3 years
Well, the paper towel was a dumb Idea because the pinda prob...

In forum Assembly and first prints troubleshooting

před 3 years
@cwbullet I can't go lower. It's hard to see in the photo, ...

In forum Assembly and first prints troubleshooting

před 3 years
It doesn't. For those of us with Mini+ that don't level cor...

In forum Hardware, firmware and software help

před 3 years
Bed leveling fails

In forum Assembly and first prints troubleshooting

před 3 years
I can help you, what color would you like? Also what materi...

In forum Prusa i3 kit (Archive)

před 7 years
Whelp, I think I have finally resolved this, and it was a hu...

In forum Others (Archive)

před 7 years
Thanks for your reply. I tried doing bed level correction, ...

In forum Others (Archive)

před 7 years
Did the above test and results were not good. If I back the...

In forum Others (Archive)

před 7 years
Does this have the live Z gcode command at the start of the ...

In forum Assembly and first prints troubleshooting

před 7 years
I'm going to grab some better alcohol at the store today, wh...

In forum Others (Archive)

před 7 years
Top is pretty smooth TBH. The issue with live z is, if I go...

In forum Others (Archive)

před 7 years
Help with inconsistent first layer and curling

In forum Others (Archive)

před 7 years
Try this. Don't know if I have taken enough off, and it is ...

In forum Improvements (Archive)

před 7 years
Stránka 1 / 2
Share: