Prusa3D Forum

Notifications

Clear all

GarretV

Groupe: Enregistré

A(ont) rejoint: 2022/04/13

Active Member

	I like that idea. Yeah, I’ll stick with my fan till it dies.... Dans le forum Hardware, firmware and software help	il y a 1 year
	Ok, so my problem appears to be with the print fan even thou... Dans le forum Hardware, firmware and software help	il y a 1 year
	The old fan was working fine before disassembly and it spins... Dans le forum Hardware, firmware and software help	il y a 1 year
	Finished mine yesterday with the exact same issue as you. I ... Dans le forum Hardware, firmware and software help	il y a 1 year
	@Incendium87 That's it!! The first post in this whole thread... Dans le forum PrusaSlicer	il y a 3 years
	Could the grub screw be tightened on the round side of the s... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	When I checked my IR sensor reading at the menu Support / Se... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Update: My issue was indeed the sensor in the extruder. It w... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Same issue here. It started happening for me during a multi-... Dans le forum Assembly and first prints troubleshooting	il y a 3 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.8 K Messages

12 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé