Notifications
Clear all
gareth.ky
gareth.ky
Skupina: Registrovaný
Přidal se: 2023/10/04
Active Member
1
They changed it after they launched the XL and MK4. With ver...

In forum Hardware, firmware and software help

před 2 months
I’m mostly interested in the power supply for the air filter...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 6 months
I guess its called the "Smart Enclosure" and its visible in ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 7 months
Yes, I think this would be a good second or third klipper pr...

In forum General discussion, announcements and releases

před 10 months
Yes you have to flash it. It’s not for the “average user”. I...

In forum General discussion, announcements and releases

před 10 months
Is there anyone interested in trying this out? I have been w...

In forum General discussion, announcements and releases

před 10 months
I opened an issue to investigate integrating that pattern:/p...

In forum Hardware, firmware and software help

před 12 months
I had not seen that one. I don't like the ones that require ...

In forum Hardware, firmware and software help

před 12 months
I added support for .bgcode files via Prusa's library, so yo...

In forum Hardware, firmware and software help

před 1 year
Here is the tool: The code is on github and there is a mode...

In forum Hardware, firmware and software help

před 1 year
I suspect we can change the stock nozzle cleaning routine to...

In forum General discussion, announcements and releases

před 1 year
Some results! Here you can see the pressure advance pattern,...

In forum Hardware, firmware and software help

před 1 year
I had not tried it. (I was mainly trying to get the pressure...

In forum Hardware, firmware and software help

před 1 year
Ugh, just adding in the M572 command isn't going to be enoug...

In forum Hardware, firmware and software help

před 1 year
Pressure Advance Tuning / M572

In forum Hardware, firmware and software help

před 1 year
Share: