Notifications
Clear all
gareth.ky
gareth.ky
Group: Registered
Joined: 2023/10/04
Active Member
1
They changed it after they launched the XL and MK4. With ver...

In forum Hardware, firmware and software help

11 months ago
I’m mostly interested in the power supply for the air filter...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I guess its called the "Smart Enclosure" and its visible in ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Yes, I think this would be a good second or third klipper pr...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Yes you have to flash it. It’s not for the “average user”. I...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Is there anyone interested in trying this out? I have been w...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I opened an issue to investigate integrating that pattern:/p...

In forum Hardware, firmware and software help

2 years ago
I had not seen that one. I don't like the ones that require ...

In forum Hardware, firmware and software help

2 years ago
I added support for .bgcode files via Prusa's library, so yo...

In forum Hardware, firmware and software help

2 years ago
Here is the tool: The code is on github and there is a mode...

In forum Hardware, firmware and software help

2 years ago
I suspect we can change the stock nozzle cleaning routine to...

In forum General discussion, announcements and releases

2 years ago
Some results! Here you can see the pressure advance pattern,...

In forum Hardware, firmware and software help

2 years ago
I had not tried it. (I was mainly trying to get the pressure...

In forum Hardware, firmware and software help

2 years ago
Ugh, just adding in the M572 command isn't going to be enoug...

In forum Hardware, firmware and software help

2 years ago
Pressure Advance Tuning / M572

In forum Hardware, firmware and software help

2 years ago
Share: