Prusa3D Forum

Notifications

Clear all

fuchsr

Groupe: Enregistré

A(ont) rejoint: 2024/09/13

Active Member

	I use that same camera with a Mk3.5 no problem. The camera d... Dans le forum Buddy3D	il y a 2 weeks
	6.4 alpha is broken. See For me it crashes big time when try... Dans le forum Hardware, firmware and software help	il y a 7 months
	You can also check the actual speed in the preview, which sh... Dans le forum PrusaSlicer	il y a 7 months
	I would not try printing PCCF without drying it first. Dans le forum How do I print this? (Printing help)	il y a 7 months
	This is the way. All my printers sit on smart switches, so a... Dans le forum Hardware, firmware and software help	il y a 10 months
	Remember that the smooth sheet is about 0.4mm thicker than s... Dans le forum Hardware, firmware and software help	il y a 1 year
	Make sure you're in Expert user mode in Prusaslicer, go to P... Dans le forum Hardware, firmware and software help	il y a 1 year
	Try /p> I forgot that the sorry forum software automatically... Dans le forum PrusaSlicer	il y a 1 year
	Did anyone else see something other than 'product temporaril... Dans le forum General discussion, announcements and releases	il y a 1 year
	I upgraded most of my Mk3's to Mk4's but one I upgraded to a... Dans le forum General discussion, announcements and releases	il y a 1 year

Statistiques du forum

598 Forums

71.3 K Sujets

500.4 K Messages

11 En-ligne

82 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé