Notifications
Clear all
Frank O
Frank O
Skupina: Registrovaný
Přidal se: 2017/10/29
Trusted Member
3
What causes this layer shift during printing?

In forum How do I print this? (Printing help)

před 3 years
How much clearance between nesting objects?

In forum How do I print this? (Printing help)

před 3 years
Thanks. More of a smear was what I had in mind. I have some ...

In forum How do I print this? (Printing help)

před 3 years
Thanks, all good to know. That's a helpful reminder about th...

In forum How do I print this? (Printing help)

před 3 years
How does choice of Print Setting in PrusaSlicer affect adhes...

In forum How do I print this? (Printing help)

před 3 years
Thanks. When you say PETG requires a bit less squish, is tha...

In forum General discussion, announcements and releases

před 3 years
Understanding Z offset when using different filaments

In forum General discussion, announcements and releases

před 3 years
Thanks!

In forum PrusaSlicer

před 3 years
Unexpected filament change

In forum PrusaSlicer

před 3 years
Thanks!

In forum How do I print this? (Printing help)

před 3 years
Best material for clear (or nearly clear) filament?

In forum How do I print this? (Printing help)

před 3 years
Thanks. Yes, it's PLA. It seems odd that dampness would be t...

In forum Hardware, firmware and software help

před 3 years
Just a follow-up on this. I disassembled the extruder, and f...

In forum Hardware, firmware and software help

před 3 years
Thanks! That's exactly it. I gather the idler plug needs to ...

In forum Hardware, firmware and software help

před 3 years
Thanks for the suggestion. It looks as though the filament i...

In forum Hardware, firmware and software help

před 3 years
Thanks. This is what I see: It seems to me that the Bondtec...

In forum Hardware, firmware and software help

před 3 years
Filament is sticking during load

In forum Hardware, firmware and software help

před 3 years
Thanks. I put my metal spatula just underneath the PINDA, an...

In forum Hardware, firmware and software help

před 4 years
Thanks. Under Support > Sensor Info it says: PINDA: 0 I'm...

In forum Hardware, firmware and software help

před 4 years
Where is PINDA status on the LCD menu?

In forum Hardware, firmware and software help

před 4 years
Stránka 2 / 3
Share: