Avisos
Vaciar todo
Frank Keene
Grupo: Registrado
Registrado: 2022/06/12
Active Member
1
|
Ok, so I decided to try going back to the 0.4mm nozzle. The... En el foro PrusaSlicer |
hace 3 years | |
|
Ok, printed a 20mm X 20mm X 12mm calibration cube that I sli... En el foro PrusaSlicer |
hace 3 years | |
|
Hi Neophyl, I sliced the STL with Cura 4.12.1 (Version I had... En el foro PrusaSlicer |
hace 3 years | |
|
Neophyl, I verified that the firmware still reports the corr... En el foro PrusaSlicer |
hace 3 years | |
|
One more important thing. I confirmed that I get the same r... En el foro PrusaSlicer |
hace 3 years | |
|
Thanks for your help Neophyl. I posted updated info. I am ... En el foro PrusaSlicer |
hace 3 years | |
|
The only changes I made to my printing setup between properl... En el foro PrusaSlicer |
hace 3 years | |
|
Understood. I checked the bug fixes and none addressed this... En el foro PrusaSlicer |
hace 3 years | |
|
Got it. Here's the zip.ZTest En el foro PrusaSlicer |
hace 3 years | |
|
Encountering a scaling issue when adding supports using supp... En el foro PrusaSlicer |
hace 3 years |