Notifications
Clear all
Frank
Groupe: Enregistré
A(ont) rejoint: 2020/09/21
Active Member
1
|
Curiosity, E3D Revo Micro mod, Octopi temperature graph Dans le forum User mods - OctoPrint, enclosures, nozzles, ... |
il y a 2 years | |
|
I checked the z-height setting by eye and did not see any ef... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
I started from 4.3.4 had the same issue as 4.3.3. Hence the ... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Short update, firmware version 4.2.1 fixes the problem and 4... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Sure, initially I noticed it during the calibration wizard. ... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
First layer calibration and z-height Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
First layer calibration and z-height Dans le forum Hardware, firmware and software help |
il y a 3 years |