Notifications
Clear all
Francesco
Skupina: Registrovaný
Přidal se: 2019/02/18
Active Member
1
|
Strange surface look on the side of my prints In forum Hardware, firmware and software help |
před 6 months | |
|
Just for information. It was the security level (WPA/PSK) th... In forum Prusa Connect & PrusaLink |
před 6 months | |
|
Security level of Wifi network essential for connection to w... In forum Prusa Connect & PrusaLink |
před 6 months | |
|
Thanks for all your replies! Well, I tried to turn off the 5... In forum Prusa Connect & PrusaLink |
před 6 months | |
|
What happens if 2.4GHz and 5GHz have the same SSID? In forum Prusa Connect & PrusaLink |
před 6 months | |
|
Using SD card extender In forum Hardware, firmware and software help |
před 2 years | |
| @morphias Oh, by the way, I forgot to ask - did you run into... | před 5 years | |
| @morphias Awesome! thanks a lot. | před 5 years | |
| @morphias Thanks a lot for your quick reply! Where do I find... | před 5 years | |
| Prusament issue - filament catching in the roll notch | před 5 years |