Notifications
Clear all
FoxRun3D
FoxRun3D
Group: Registered
Joined: 2024/08/13
Famed Member
You'd have to make so many changes, including drilling out p...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
No suggestions but watching this thread with interest as I h...

In forum Hardware, firmware and software help

1 year ago
Yes, this super useful feature got lost in the transition fr...

In forum Hardware, firmware and software help

1 year ago
No, you're not, and yes, it should—but it doesn't. It really...

In forum How do I print this? (Printing help)

1 year ago
Yup, my money is on this one. Use the F key to make sure the...

In forum PrusaSlicer

1 year ago
I think this is a limitation in Fusion 360. I usually just s...

In forum PrusaSlicer

1 year ago
I'd revert back to 4.7.2 to make sure it's related to firmwa...

In forum How do I print this? (Printing help)

1 year ago
OMG — Miracles happen! Simple QoL improvements like this don...

In forum General discussion, announcements and releases

1 year ago
I've found my Minis to print as nicely and as reliably as my...

In forum General discussion, announcements and releases

1 year ago
Print Settings→Infill→Advanced→Fill Angle. You have to be in...

In forum PrusaSlicer

1 year ago
The only upgrade I wholeheartedly recommend is the Bondtech ...

In forum General discussion, announcements and releases

1 year ago
In the article it says, that the offset done during the firs...

In forum Assembly and first prints troubleshooting

1 year ago
I started with the Prusa-recommended method of removing the ...

In forum Hardware, firmware and software help

1 year ago
Fusion 360 hobbyist license TinkerCad FreeCad SketchUp...

In forum General discussion, announcements and releases

1 year ago
What you're seeing is standard behavior in 2.6, to improve t...

In forum PrusaSlicer

1 year ago
I suspect you're doing nothing wrong, they just don't suppor...

In forum General discussion, announcements and releases

1 year ago
In Printer Settings→Custom G-code→Start G-code, change the l...

In forum PrusaSlicer

1 year ago
In general you should be good if * you don't include a corp...

In forum General discussion, announcements and releases

1 year ago
I gave up swapping nozzles the Prusa Way. I just do it the M...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Check out the Wyze Cam 3 ($32) on Amazon/p> For a few bucks ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Page 45 / 241
Share: