English
Forums
Members
Flynny75
Activity
 
Notifications
Clear all
Flynny75
Flynny75
Group: Registered
Joined: 2023/07/26
Active Member
1
Profile Activity
Have you thought about drilling coupler holes into the top c...

In forum Community mods

 7 months ago
After starting a job and leaving it for a some unknown time,...

In forum Bugs & Errors

 7 months ago
I was mistaken in my jubilation earlier. This is still an is...

In forum Bugs & Errors

 7 months ago
Coincidentally, this has been much more reliable since I rep...

In forum Bugs & Errors

 8 months ago
This happens almost every time for me. I slice, click 'Send ...

In forum Bugs & Errors

 9 months ago
I am now very suspicious of my X axis bearing block. When th...

In forum Assembly and first prints troubleshooting

 2 years ago
Are the specifications of the motors and linear bearings sta...

In forum Assembly and first prints troubleshooting

 2 years ago
Unfortunately the dab of superglue did not help. Moving the ...

In forum Assembly and first prints troubleshooting

 2 years ago
I am also experiencing loud rattles from the toolhead. They ...

In forum Assembly and first prints troubleshooting

 2 years ago
I have received and fitted the new parts, the printer is now...

In forum Assembly and first prints troubleshooting

 2 years ago
Prusa support have directed me towards a new support page/p>...

In forum Assembly and first prints troubleshooting

 2 years ago
The PCB is already electronically isolated from the tiles an...

In forum Assembly and first prints troubleshooting

 2 years ago
I printed some 8.5mm spacers and reattached the PCB using M3...

In forum Assembly and first prints troubleshooting

 2 years ago
It is the back, but also the right. Does back left exhibit t...

In forum Assembly and first prints troubleshooting

 2 years ago
I have removed the PCB from the bottom of the heated bed. I ...

In forum Assembly and first prints troubleshooting

 2 years ago
I have checked all my wires and have no damage 🙁 I am still...

In forum Assembly and first prints troubleshooting

 2 years ago
I put the machine on its side, remove the heat bed bottom co...

In forum Assembly and first prints troubleshooting

 2 years ago
Spoke too soon. It was working fine, I leave it for a few ho...

In forum Assembly and first prints troubleshooting

 2 years ago
I removed and reassembled my bed, and I can now reliably hea...

In forum Assembly and first prints troubleshooting

 2 years ago
I am also experiencing this issue. I can complete small prin...

In forum Assembly and first prints troubleshooting

 2 years ago
Share: