Prusa3D Forum

Notifications

Clear all

FlyingCog

Skupina: Registrovaný

Přidal se: 2021/08/04

Active Member

	@dan-rogers - I think you misunderstood me: I'm moving from ... In forum How do I print this? (Printing help)	před 3 years
	10% infill caused warping so 20% or 30% is needed. In forum How do I print this? (Printing help)	před 3 years
	Ok. I printed a lot of enclosure with 30% infil. Will try 10... In forum How do I print this? (Printing help)	před 3 years
	Fire safety concerns means I don't want to run overnight or ... In forum How do I print this? (Printing help)	před 3 years
	Are you software engineer or mathematician 😉 In forum How do I print this? (Printing help)	před 3 years
	Is there a reason to choose 10-20% grid over 30% adoptive gr... In forum How do I print this? (Printing help)	před 3 years
	I will check this method. It seems to be very small holes (I... In forum Assembly and first prints troubleshooting	před 3 years
	How much unattended can my printer be In forum General discussion, announcements and releases	před 3 years
	Sorry - it seems to be problem with forum software as I adde... In forum Assembly and first prints troubleshooting	před 3 years
	Heatbed resistance 4 ohms - problem? In forum Hardware, firmware and software help	před 3 years
	Was z-level calibration done correctly? In forum Assembly and first prints troubleshooting	před 3 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.3 K Příspěvky

24 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed