Prusa3D Forum

Notifications

Clear all

FlyingCog

Group: Registered

Joined: 2021/08/04

Active Member

	@dan-rogers - I think you misunderstood me: I'm moving from ... In forum How do I print this? (Printing help)	3 years ago
	10% infill caused warping so 20% or 30% is needed. In forum How do I print this? (Printing help)	3 years ago
	Ok. I printed a lot of enclosure with 30% infil. Will try 10... In forum How do I print this? (Printing help)	3 years ago
	Fire safety concerns means I don't want to run overnight or ... In forum How do I print this? (Printing help)	3 years ago
	Are you software engineer or mathematician 😉 In forum How do I print this? (Printing help)	3 years ago
	Is there a reason to choose 10-20% grid over 30% adoptive gr... In forum How do I print this? (Printing help)	3 years ago
	I will check this method. It seems to be very small holes (I... In forum Assembly and first prints troubleshooting	3 years ago
	How much unattended can my printer be In forum General discussion, announcements and releases	3 years ago
	Sorry - it seems to be problem with forum software as I adde... In forum Assembly and first prints troubleshooting	3 years ago
	Heatbed resistance 4 ohms - problem? In forum Hardware, firmware and software help	3 years ago
	Was z-level calibration done correctly? In forum Assembly and first prints troubleshooting	3 years ago

Forum Statistics

565 Forums

63.8 K Topics

447.2 K Posts

19 Online

69.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed