|
Typo in my last reply: Still returns to the *wrong* Z height... Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
Update: Still returns to the Z height in Firmware 6.2.4 The ... Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
This happens to me too on 6.2.1. I am still using the Prusa ... Dans le forum General discussion, announcements and releases |
il y a 7 months |
|
I can reproduce it in 6.2.0 alpha 1 and alpha 2. I currently... Dans le forum Hardware, firmware and software help |
il y a 7 months |
|
Thanks for all the replies. To test, I have been printing a ... Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
I tried doing a hard reset and loading 6.2.0 alpha 1. This d... Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
Thank you for the response. That was my first thought, so I ... Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
Spool join results in bad layer Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
Thanks for the response. See file here: CaseMount1ExportTest... Dans le forum PrusaSlicer |
il y a 9 months |
|
2.9.0 Snap Connector Separated in Slicer Dans le forum PrusaSlicer |
il y a 9 months |
|
This still happens to me in 6.2.0 alpha 2. I can still recov... Dans le forum Hardware, firmware and software help |
il y a 10 months |
|
I still had the issue with 6.2.0 alpha1 but it was less comm... Dans le forum Hardware, firmware and software help |
il y a 10 months |
|
Tried again with 6.2 alpha. I had 4-5 successful 8+ hour pri... Dans le forum Hardware, firmware and software help |
il y a 12 months |
|
I just installed 6.2.0 alpha to fix the USB issue. That appe... Dans le forum Hardware, firmware and software help |
il y a 12 months |
|
Any tips for the Sunlu S4 dryer actually drying? I got one b... Dans le forum User mods - OctoPrint, enclosures, nozzles, ... |
il y a 1 year |
