Notifications
Clear all
florin.f2
florin.f2
Skupina: Registrovaný
Přidal se: 2017/03/26
Eminent Member
2
@joan.t : Yeah, that should my next thing to address, qualit...

In forum Others (Archive)

před 7 years
Evrika .... finally I managed to find the issue ... wasn't v...

In forum Others (Archive)

před 7 years
I don't get it ... some strands seem to be layed down correc...

In forum Others (Archive)

před 7 years
I can't seem to get past first layer calibration :(( . Need ...

In forum Others (Archive)

před 7 years
Thanks for the answers I might had it mixed up with the +Z ....

In forum Others (Archive)

před 7 years
I have lowered the PIDA quite a bit, I wouldn't go further b...

In forum Others (Archive)

před 7 years
My 0.000 Live Z Adjustmet is still too far away from bed

In forum Others (Archive)

před 7 years
is there any (structural) reason for Y-PSY-Part?

In forum Prusa i3 kit (Archive)

před 7 years
Made a spinning surface plot from the data and it looks pret...

In forum Prusa i3 kit (Archive)

před 7 years
Prusa i3 MK2S :: Take II :: Some Conclusions

In forum Prusa i3 kit (Archive)

před 7 years
Played with plot.ly a bit :

In forum Prusa i3 kit (Archive)

před 7 years
Those inserts are fully bottomed with the screws fastened pr...

In forum Prusa i3 kit (Archive)

před 7 years
Hi Henrik, Yes I did and there was no way to answer that bu...

In forum Prusa i3 kit (Archive)

před 7 years
Thanks man for this method, it was soo easy to work on Y-to-...

In forum Prusa i3 kit (Archive)

před 7 years
These teething problems seem to never end 🙁 . Not sure you ...

In forum Prusa i3 kit (Archive)

před 7 years
Ok, managed to get to the values below pretty straight-fw bu...

In forum Prusa i3 kit (Archive)

před 7 years
I have no idea how to plot a 3d heatmap of the numbers so on...

In forum Prusa i3 kit (Archive)

před 7 years
I wouldn't take it apart to that point where I can measure t...

In forum Prusa i3 kit (Archive)

před 7 years
Some more numbers: * got the labels in the...

In forum Prusa i3 kit (Archive)

před 7 years
And some more: ...

In forum Prusa i3 kit (Archive)

před 7 years
Stránka 1 / 2
Share: