Prusa3D Forum

Notifications

Clear all

Floh0815

Skupina: Registrovaný

Přidal se: 2021/12/30

Active Member

	I increased the the live z now to -0.850 and now it does wor... In forum Assembly and first prints troubleshooting	před 3 years
	I changed the live Z to -0.840 and redid the square (check p... In forum Assembly and first prints troubleshooting	před 3 years
	Here is a fully printed calibration square. Same problem, bu... In forum Assembly and first prints troubleshooting	před 3 years
	Do you mean the underside after peeling it off the bed or ju... In forum Assembly and first prints troubleshooting	před 3 years
	First few mm of new line not sticking to bed In forum Assembly and first prints troubleshooting	před 3 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.3 K Příspěvky

20 Online

69 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed