Deutsch
Foren
Mitglieder
flashburn
Aktivität
 
Benachrichtigungen
Alles löschen
flashburn
flashburn
Gruppe: Registriert
Beigetreten: 2018/10/08
Active Member
1
Profil Aktivität
I retried printing at 0.25 and those prints come out fine.

Im Forum How do I print this? (Printing help)

 Vor 4 years
I just tried changing the MVS to 11.5, but it didn't change ...

Im Forum How do I print this? (Printing help)

 Vor 4 years
I tried reducing the speed down to 50% but it still looks ex...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Thanks a lot for the help! I'm reprinting a smaller one now ...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Oh, yeah I see what you mean. I'm not sure then, maybe you a...

Im Forum How do I print this? (Printing help)

 Vor 4 years
I thought you can do 80% nozzle size in layer height? I'm no...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Weird defects on walls of prints - MK3S

Im Forum How do I print this? (Printing help)

 Vor 4 years
I should note that I made a stupid math error in both posts,...

Im Forum Hardware, firmware and software help

 Vor 6 years
Oh, thanks guys! I had no idea. I just tried .32mm and that ...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
yes, should not split, and I would say you can notice them. ...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
What am I looking for in a "good" calibration? Should the li...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
what fails? does it come off the bed, or does something else...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
I could really use some help dialing in my Z. I'm basically ...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
Teilen: