|
The best place to rest the bed when Z-aligning is as close t... En el foro Hardware, firmware and software help |
hace 4 months |
|
This is my solution/p> En el foro Hardware, firmware and software help |
hace 4 months |
|
Hi, I packed the printer in its original packaging. I took i... En el foro Hardware, firmware and software help |
hace 4 months |
|
So I finally got my printer back and I would like to share w... En el foro Hardware, firmware and software help |
hace 4 months |
|
I have been using HF obxidian for about a year on all materi... En el foro Hardware, firmware and software help |
hace 5 months |
|
Of course, I will send information about the result of the c... En el foro Hardware, firmware and software help |
hace 5 months |
|
I think a difference of 0.5 mm is quite okay, unlike 1.9 mm.... En el foro Hardware, firmware and software help |
hace 5 months |
|
Thanks for the response and advice. I would expect that a Pr... En el foro Hardware, firmware and software help |
hace 5 months |
|
RE: The bed is not leveled !!! En el foro Hardware, firmware and software help |
hace 5 months |
|
Height difference HB visible to the naked eye. En el foro Hardware, firmware and software help |
hace 5 months |
|
I'm also wondering if this is really normal for core XY prin... En el foro Hardware, firmware and software help |
hace 5 months |
|
Transcript of part of the communication with the service cen... En el foro Hardware, firmware and software help |
hace 5 months |
|
Thank you all for your responses and advice. Unfortunately, ... En el foro Hardware, firmware and software help |
hace 6 months |
|
It's a shame there are no assembly instructions yet. I've al... En el foro Hardware, firmware and software help |
hace 6 months |
|
I will be complaining about the printer. En el foro Hardware, firmware and software help |
hace 6 months |
|
And yes, XY transport is different in the front and back, an... En el foro Hardware, firmware and software help |
hace 6 months |
|
Exactly, the X,Y frame is not parallel to the bottom stops. ... En el foro Hardware, firmware and software help |
hace 6 months |
|
I solved the problem my way by putting washers of the right ... En el foro Hardware, firmware and software help |
hace 6 months |
|
I am sorry, not the shim, but I mean bed. En el foro Hardware, firmware and software help |
hace 6 months |
|
The bed is not leveled !!! En el foro Hardware, firmware and software help |
hace 6 months |
