Prusa3D Forum

Notifications

Clear all

ffdez

Skupina: Registrovaný

Přidal se: 2021/06/12

Active Member

	Hi. I took @jmone setup for eSUN PA-CF (I stronly suggest yo... In forum PrusaSlicer	před 3 years
	Hi. Try Garolite. I use it with success (no glue or anything... In forum How do I print this? (Printing help)	před 3 years
	Good morning. The last two trials results. a) 100.8% X/Y a... In forum PrusaSlicer	před 3 years
	@jmone I have a dehydrator and the a Sunlu filadryer. The pr... In forum PrusaSlicer	před 3 years
	Hi. 101% in X and Y with 100.5% in Z was almost in the money... In forum PrusaSlicer	před 3 years
	@jmone Got it. Thanks. I'll post later results. In forum PrusaSlicer	před 3 years
	@jmone Hi. I did place the spool into a dehidrator @ 70C for... In forum PrusaSlicer	před 3 years
	@jmone Hi. More or less 0.003"/1" In forum PrusaSlicer	před 3 years
	@jmone I did use the setting for a spur gear to see differen... In forum PrusaSlicer	před 3 years
	@jmone Thanks. I'll try and let you know. In forum PrusaSlicer	před 3 years
	@jmone Hi. Can you share your prusaslicer settings for eSun ... In forum PrusaSlicer	před 3 years
	Thanks, solved In forum Assembly and first prints troubleshooting	před 4 years
	@cwbullet Thanks. Solved. In forum Assembly and first prints troubleshooting	před 4 years
	First layer not sticking to bed In forum Assembly and first prints troubleshooting	před 4 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.3 K Příspěvky

21 Online

69 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed