Notifications
Clear all
Felenari
Felenari
Skupina: Registrovaný
Přidal se: 2021/05/17
Eminent Member
2
I noticed the first layer almost always starting at 0.2mm. I...

In forum How do I print this? (Printing help)

před 3 years
Printing 0.1 when set to 0.05l?

In forum How do I print this? (Printing help)

před 3 years
I'll try that tomorrow tyty.

In forum How do I print this? (Printing help)

před 3 years
Tried your settings. Everything went great but it still wont...

In forum How do I print this? (Printing help)

před 3 years
Thank you very much. I'll give it a try tomorrow and post re...

In forum How do I print this? (Printing help)

před 3 years
I'll read that one now Ty. Just tried the M600 after I add...

In forum How do I print this? (Printing help)

před 3 years
Tyty. I'll give the M600 a run tomorrow when I get home.

In forum How do I print this? (Printing help)

před 3 years
Missed the attached file twice. 😛 tyty. I'll check it out ...

In forum How do I print this? (Printing help)

před 3 years
Is there perhaps an article explaining the gcode edit?

In forum How do I print this? (Printing help)

před 3 years
I'll check out those settings and print a calibration cube f...

In forum How do I print this? (Printing help)

před 3 years
I don't have any strong filaments in a transparent red and w...

In forum How do I print this? (Printing help)

před 3 years
Does the g600 make it a filament swap instead of a different...

In forum How do I print this? (Printing help)

před 3 years
Material switch mid print?

In forum How do I print this? (Printing help)

před 3 years
Been printing some cpe parts and they look pretty good. The ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 3 years
I don't have either of those filaments. My cpe is my highest...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 3 years
Cpe is a high temp kind of petg if I remember right. I don't...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 3 years
Cpe for extruder parts?

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 3 years
I'm going to have to try this since I blew my whole budget o...

In forum How do I print this? (Printing help)

před 3 years
Got a new hotend from Amazon and installed my ruby. Works gr...

In forum Hardware, firmware and software help

před 3 years
Tyty. Would this be a drop in replacement for my stock mk3s...

In forum Hardware, firmware and software help

před 3 years
Stránka 1 / 3
Share: