Benachrichtigungen
Alles löschen
Extrutim
Extrutim
Gruppe: Registriert
Beigetreten: 2019/12/15
Eminent Member
2
I had a proper layer shift during the first test print with ...

Im Forum General discussion, announcements and releases

Vor 10 months
But mechanically everything is fine. Without automatic bed l...

Im Forum Hardware, firmware and software help

Vor 10 months
The self-test on the Mini does not include the search for me...

Im Forum Hardware, firmware and software help

Vor 10 months
First layer problems, no solution from support

Im Forum Hardware, firmware and software help

Vor 10 months
This occurs with all extruders. I would like to have the pri...

Im Forum Hardware, firmware and software help

Vor 11 months
I found out for myself today. I overlooked to switch from Pr...

Im Forum PrusaSlicer

Vor 11 months
Sending gcodes from Prusaslicer to Prusa Connect doesn't wor...

Im Forum PrusaSlicer

Vor 11 months
I am also trying to find out where this resonance in the vid...

Im Forum Hardware, firmware and software help

Vor 11 months
I have now done a few tests and compared the print quality a...

Im Forum Hardware, firmware and software help

Vor 11 months
I also had problems with bed leveling at the beginning.It co...

Im Forum Hardware, firmware and software help

Vor 11 months
Another thing I'm wondering: wasn't it said that sensors are...

Im Forum Hardware, firmware and software help

Vor 12 months
I have now scaled the model larger in X and Y to increase th...

Im Forum Hardware, firmware and software help

Vor 12 months
I also had this problem and wrote to support about this. I s...

Im Forum Hardware, firmware and software help

Vor 12 months
Where? The idle temperature in the filament profile is not a...

Im Forum Hardware, firmware and software help

Vor 12 months
Oh right, the file was not attached. I didn't notice this th...

Im Forum Hardware, firmware and software help

Vor 12 months
Multi Color printing one extruder always needs time to heat ...

Im Forum Hardware, firmware and software help

Vor 12 months
Sehr gut, der Link hilft mir jedenfalls schonmal etwas mit d...

Im Forum Benutzermodifikationen - OctoPrint, Gehäuse, Düsen, …

Vor 4 years
Licht an sich ist nicht das Problem am Drucker, da habe ich ...

Im Forum Benutzermodifikationen - OctoPrint, Gehäuse, Düsen, …

Vor 4 years
Beleuchtung der Nozzle

Im Forum Benutzermodifikationen - OctoPrint, Gehäuse, Düsen, …

Vor 4 years
Extruderteile SLA drucken?

Im Forum Wie drucke ich das? (Hilfe zum Drucken)

Vor 4 years
Seite 1 / 2
Teilen: