Notifications
Clear all
EvoDesigns
EvoDesigns
Group: Support
Joined: 2024/02/06
Title: Member
PrintedSolid charges $18 to ship a GPIO board within the sta...

In forum General discussion, announcements and releases

6 months ago
I had issues with PCCF last week and I could not get it to p...

In forum Assembly and first prints troubleshooting

6 months ago
what filament type are you using?

In forum Assembly and first prints troubleshooting

6 months ago
I got a new phone last year and lost my 2FA with it. I was l...

In forum Hardware, firmware and software help

6 months ago
Check out my design to retrofit the old filter/blower.

In forum Hardware, firmware and software help

7 months ago
Advanced Filtration System

In forum Hardware, firmware and software help

8 months ago
Will do buddy, I'll keep printing with my flickering LED too...

In forum Hardware, firmware and software help

9 months ago
I'm almost certain the flickering LEDs have nothing to do wi...

In forum Hardware, firmware and software help

9 months ago
I swapped out the dwarf board and the tool has printed about...

In forum Hardware, firmware and software help

10 months ago
So they said, "hey we know the problem, don't tell anyone" g...

In forum Hardware, firmware and software help

10 months ago
Yup, all texts are ready here and there is multiple problems...

In forum Hardware, firmware and software help

10 months ago
Get them replaced under warranty then. I just printed 12h...

In forum Hardware, firmware and software help

10 months ago
Just buy a new dwarf board.

In forum Hardware, firmware and software help

10 months ago
Hold on to your bet. Different material parts won't solve th...

In forum Hardware, firmware and software help

10 months ago
Work backwards from the build instructions.

In forum General discussion, announcements and releases

10 months ago
The microcontroller on the latest board is slightly differen...

In forum Hardware, firmware and software help

10 months ago
I have two tool heads. T1 is the tool that I have issues wi...

In forum Hardware, firmware and software help

10 months ago
There will always be a "latest and greatest" iteration of wh...

In forum General discussion, announcements and releases

10 months ago
How do we check if its a pre release?

In forum Hardware, firmware and software help

10 months ago
Use 3mm ID PTFE tubing. I had the same issue.

In forum Hardware, firmware and software help

11 months ago
Page 1 / 2
Share: