|
problem seems to be resolved. our assistant was downloadin... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
thank you for the tips, you are right in all points. machine... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
you can reread our original post. we have tried all this. we... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
prusa support suggested logic board failure. waiting for rep... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
adding spacers is the same with having cables or whatever bl... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
X, Y shafts and gears seem to work as one piece without slip... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
@tim-m30 will check the axles, thank you, might explain the ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
thanks for the reply, we have checked all collisions (prior ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
thanks for the feedback, yes, we have disabled the fillament... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
MK3s XYZ Calibration failed! Check the axes and run again Dans le forum Hardware, firmware and software help |
il y a 5 years |
