Prusa3D Forum

Notifiche

Cancella tutti

Evan Judson

Gruppo: Registrato

Registrato: 2024/05/23

Active Member

	Thanks, I actually thought about splitting it not too long a... Nel forum How do I print this? (Printing help)	1 month fa
	Flat spots/bad finish separation on supported round arc part Nel forum How do I print this? (Printing help)	2 months fa
	oh and i've tried it on speeds 100, 150, 200, and 250 thinki... Nel forum How do I print this? (Printing help)	8 months fa
	PLA warping/adhesion issue? Corner keeps lifting causing cra... Nel forum How do I print this? (Printing help)	8 months fa
	Thanks gents, exactly what I was hoping to hear. I've got so... Nel forum General discussion, announcements and releases	8 months fa
	Filament that is strong and oil/water resistant? Nel forum General discussion, announcements and releases	8 months fa

Statistiche Forum

565 Forum

64.1 K Discussioni

449.1 K Post

20 Online

70.2 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso