Prusa3D Forum

Notifications

Clear all

eudoxos

Groupe: Enregistré

A(ont) rejoint: 2020/03/27

Active Member

	@joantabb The nut was somehow glued to the screw and if turn... Dans le forum Hardware, firmware and software help	il y a 5 years
	@joantabb BTW I appreaciate you answering on the forum. Chee... Dans le forum Hardware, firmware and software help	il y a 5 years
	@joantabb Yes, it is a 2.5mm hexagon, though I believe the p... Dans le forum Hardware, firmware and software help	il y a 5 years
	Unable to dismantle extruder (for nozzle change) Dans le forum Hardware, firmware and software help	il y a 5 years
	Thanks for the reply. The home X Y function would be very ni... Dans le forum Hardware, firmware and software help	il y a 5 years
	recovery (recalibration without throwing away what's printed... Dans le forum Hardware, firmware and software help	il y a 5 years
	Is it okay to print at 200%? Any long-term side-effects? Dans le forum General discussion, announcements and releases	il y a 5 years
	Is there some overview of designs available? The is the offi... Dans le forum Coronavirus (COVID-19)	il y a 5 years

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

21 En-ligne

70.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé