Čeština
Fóra
Uživatelé
erick.v
Aktivita
 
Notifications
Clear all
erick.v
erick.v
Skupina: Registrovaný
Přidal se: 2016/11/08
Estimable Member
4
Profile Aktivita
Clean the bed with acetone and run the calibration print to ...

In forum Print tips (Archive)

 před 8 years
Do you use the Glue as a release agent? My ABS prints stick ...

In forum Print tips (Archive)

 před 8 years
Thanks for all your responses I will try all your suggestion...

In forum Others (Archive)

 před 8 years
I am printing from SD card. The Printer is on a UPS I was p...

In forum Others (Archive)

 před 8 years
I have a silicon sock over my hotend and I have never had th...

In forum Others (Archive)

 před 8 years
Print finished Halfway in the print

In forum Others (Archive)

 před 8 years
What heatsink version hotend are you talking about? I have ...

In forum Others (Archive)

 před 8 years
The same thing happened to me as I posted in my other thread...

In forum Prusa i3 kit (Archive)

 před 8 years
I found the problem and Fixed it! Sorry, I couldn't take pi...

In forum Others (Archive)

 před 8 years
Cold end fan troubleshooting

In forum Others (Archive)

 před 8 years
Wow Very Good explanation! I have a few days off from work ...

In forum Improvements (Archive)

 před 8 years
David Looking at the firmware code, it is 45 seconds before...

In forum Improvements (Archive)

 před 8 years
S3D shows 10 hours for the print but the actual print time t...

In forum General discussion, announcements and releases

 před 8 years
The "fumes" are not nearly as bad as what people claim. I gu...

In forum Print tips (Archive)

 před 8 years
There are cheap and easy ways to have an enclosure even a bl...

In forum Others (Archive)

 před 8 years
Thanks for your help guys! BTW why don't you recommend the...

In forum Prusa i3 kit (Archive)

 před 8 years
E3D v6.1 Shipping with new printers and kits... Does it incl...

In forum Prusa i3 kit (Archive)

 před 8 years
Stránka 6 / 6
Share: