Prusa3D Forum

Notifications

Clear all

Eric Still

Skupina: Registrovaný

Přidal se: 2016/11/26

Active Member

	XYZ calibration fails at point 9 In forum General discussion, announcements and releases	před 3 years
	If it is a relatively large smooth surface, you can try mode... In forum Others (Archive)	před 8 years
	Check out Alclad II Lacquers. I was never able to get a tru... In forum Others (Archive)	před 8 years
	That sounds reasonable. I've only done that in OpenScad. I... In forum Software (Archive)	před 8 years
	First of all thanks for the Auto Center check box. I didn't... In forum Print tips (Archive)	před 8 years
	Can I ask, what are you trying to accomplish with a zero lay... In forum Software (Archive)	před 8 years
	Once you have to object on the print bed in Slic3r, you can ... In forum Print tips (Archive)	před 8 years
	I have a 32GB Sandisk Ultra Plus microSD card that works jus... In forum Others (Archive)	před 8 years
	I have to wonder if this is the glue. The sticker backing o... In forum Prusa i3 kit (Archive)	před 8 years
	I'm having this same issue. Were you ever able to solve it? In forum Prusa i3 kit (Archive)	před 8 years
	That's a good read. Thank you Eric In forum Prusa i3 kit (Archive)	před 8 years
	When to use support material In forum Prusa i3 kit (Archive)	před 8 years

Fórum Statistiky

559 Fóra

63.1 K Témata

443.9 K Příspěvky

22 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed