Activité
 
Notifications
Clear all
EPL
EPL
Groupe: Enregistré
A(ont) rejoint: 2020/08/08
Active Member
1
Firmware 3.14 does not work with super pinda

Dans le forum Hardware, firmware and software help

il y a 6 months
Works perfect. Thanks Matt

Dans le forum How do I print this? (Printing help)

il y a 7 months
Unfortunately that does not answer what type of thread I hav...

Dans le forum General discussion, announcements and releases

il y a 2 years
What kind of nut fits a pc4-M10 fitting?

Dans le forum General discussion, announcements and releases

il y a 2 years
Well, a Raspberry Pi Pico or ESP32 dev board is about $5. A ...

Dans le forum Hardware, firmware and software help

il y a 2 years
That basically means: Build an other 3D Printer controller. ...

Dans le forum Hardware, firmware and software help

il y a 2 years
Good point. I have one with temperatur regulation at hand.Wh...

Dans le forum Hardware, firmware and software help

il y a 2 years
I tried to increase the gap above the nozzle. That was clear...

Dans le forum How do I print this? (Printing help)

il y a 2 years
How to control the hot end with a ESP32 or Raspberry Pi Pico

Dans le forum Hardware, firmware and software help

il y a 2 years
PETG is collected at the nozle and drops on the print bed

Dans le forum How do I print this? (Printing help)

il y a 2 years
Thanks for the sugestion! It was indeed one of the linear be...

Dans le forum Hardware, firmware and software help

il y a 2 years
Strange noise when moving backwards on y-axis

Dans le forum Hardware, firmware and software help

il y a 2 years
@gkmakeit Thanks for your answer. I raised the Z layer two t...

Dans le forum How do I print this? (Printing help)

il y a 4 years
PETG makes bubbles

Dans le forum How do I print this? (Printing help)

il y a 4 years
Partager :