Benachrichtigungen
Alles löschen
ekmek
Gruppe: Registriert
Beigetreten: 2020/10/03
Active Member
1
|
Any word if PrusaSlicer will support Elegoo Mars? Im Forum PrusaSlicer |
Vor 5 years | |
|
Thanks, it could be because I did do a higher temp to get th... Im Forum Hardware, firmware and software help |
Vor 5 years | |
|
I'm having the same problem. Any way to prevent this? Im Forum Hardware, firmware and software help |
Vor 5 years | |
|
Did this get resolved? I have the same problem with OBJ impo... Im Forum PrusaSlicer |
Vor 5 years | |
|
I noticed this too. But since my PLA wouldn't stick I turne... Im Forum PrusaSlicer |
Vor 5 years | |
|
@john-h68 When I type R or a number I get nothing. Is there ... Im Forum PrusaSlicer |
Vor 5 years | |
| Well it worked for a bit. Then I ran into the issue again. ... | Vor 5 years | |
| Thanks guys this helped a lot. When I disassembled it I did... | Vor 5 years | |
| @daniel-s89 Thanks, let me block off some time and have a g... | Vor 5 years | |
| I had a similar problem. The calibration wasn't getting clos... | Vor 5 years | |
| I think I have a similar problem but I'm going to have to ta... | Vor 5 years |