Prusa3D Forum

Notifications

Clear all

eepete

Groupe: Support

A(ont) rejoint: 2026/02/04

Titre: Membre

	SUCESS ! using a similar setup to what I used on the undersi... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	Ok on "sometimes". It's the nature of tweaking anything. I p... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	That 1st line should be "Thanks" not "Thats". autocorrectin... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	Thats for those observations. I have never gone above 50% si... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	Thanks for the link and picture of what relief slots might l... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	The "internal stress" observations ring true here. When this... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	The print plate is the Prusa textured one that is for use wi... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	PETG corners of prints bending up at around the 1.3mm of thi... Dans le forum Assembly and first prints troubleshooting	il y a 3 months

Statistiques du forum

598 Forums

71.6 K Sujets

502.9 K Messages

16 En-ligne

82.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé