English
Forums
Members
EdgeSync
Activity
 
Notifications
Clear all
EdgeSync
EdgeSync
Group: Registered
Joined: 2021/09/17
Active Member
1
Profile Activity
Hey @surgeboxIf I remember correctly it did help some. I set...

In forum Assembly and first prints troubleshooting

 2 years ago
When I started getting the random rough parts in the flat fi...

In forum Hardware, firmware and software help

 3 years ago
Yep - the red came out perfect. I'm marking this a as solved...

In forum How do I print this? (Printing help)

 3 years ago
After the full calibration - this is how it looks now - to m...

In forum How do I print this? (Printing help)

 3 years ago
So I guess the slight change in the nozzle height must have ...

In forum How do I print this? (Printing help)

 3 years ago
Full wizard calibration completed - all good. I did lower th...

In forum How do I print this? (Printing help)

 3 years ago
Print gets about half way, then gets knocked off the bed?

In forum How do I print this? (Printing help)

 3 years ago
I would recommend going through the pre flight check again i...

In forum Hardware, firmware and software help

 3 years ago
Metal Gear Rex

In forum Awesome prints (Hall Of Fame)

 3 years ago
Hey all, so i guess if common consensus is moisture in the P...

In forum Assembly and first prints troubleshooting

 3 years ago
One of my worst to date. Tried printing Nefertiti overnight ...

In forum Awesome prints (Hall Of Fame)

 3 years ago
So I did notice that there seemed to be a bit more extrusion...

In forum Assembly and first prints troubleshooting

 3 years ago
Oh wow, that's something I hadn't expected. I live in a coun...

In forum Assembly and first prints troubleshooting

 3 years ago
prints are not coming out good, possible extruder / hotend i...

In forum Assembly and first prints troubleshooting

 3 years ago
Should I give the printer a break?

In forum General discussion, announcements and releases

 3 years ago
Share: