|
Hi Daniel, From the Support reply you quoted, it seems that ... En el foro Buddy3D |
hace 1 month |
|
Hi, I think it’s very unlikely that the issues are caused by... En el foro Buddy3D |
hace 1 month |
|
I have the same problem with 3.1.2. The camera that came wit... En el foro Buddy3D |
hace 1 month |
|
I think the camera auto-updates to 3.1.2 via the WiFi intern... En el foro Hardware, firmware and software help |
hace 1 month |
|
My factory-installed CHT high flow nozzle also clogged with ... En el foro Hardware, firmware and software help |
hace 1 month |
|
If Prusa Engineering is reading this forum: my setup is also... En el foro Hardware, firmware and software help |
hace 1 month |
|
The camera immediately auto-upgraded to 3.1.2 so no joy 😉 ... En el foro Hardware, firmware and software help |
hace 2 months |
|
Thank you! I will try this immediately I wish Prusa Support ... En el foro Hardware, firmware and software help |
hace 2 months |
|
Indeed - can you imagine my surprise as Prusa Support actual... En el foro Hardware, firmware and software help |
hace 2 months |
|
I have the same exact issue with my new Core One L (same Nex... En el foro Hardware, firmware and software help |
hace 2 months |
|
Hi Pedro,
I asked this same question from Prusa Support ... En el foro Hardware, firmware and software help |
hace 2 months |
|
Just guessing here - could it be something that happened / g... En el foro Hardware, firmware and software help |
hace 2 months |
|
I was asked to perform a Factory Reset (hold the reset for a... En el foro Hardware, firmware and software help |
hace 2 months |
|
My fresh Core ONE L upper belt was at 82 Hz, lower belt is a... En el foro Hardware, firmware and software help |
hace 2 months |
|
Final update: today, I was able to open the electronics box ... En el foro Hardware, firmware and software help |
hace 2 months |
|
Ooh! The QR code on the leaflet included with the kit pointe... En el foro Hardware, firmware and software help |
hace 2 months |
|
Advanced Filtration kit near impossible to connect En el foro Hardware, firmware and software help |
hace 2 months |
|
I just spent some time online with support - I sent them vid... En el foro Hardware, firmware and software help |
hace 2 months |
|
CORE One L Buddy cam always reports “WiFi connection failed”... En el foro Hardware, firmware and software help |
hace 2 months |
|
(sorry, I could not edit topic name anymore) En el foro How do I print this? (Printing help) |
hace 5 years |
