|
It worked pretty good for the last week and a half. But last... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Thank you very much for the reply and guidance. My first lay... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I can't remember, or find record of, where I got that filame... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I think it's OK now. I did the bed leveling and first layer ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I backed the heat sink out just a hair and it now quickly re... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
We have a 3D printing department where I work. I talked to t... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Thank you for the reply and assistance. I am confused beca... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I got it apart and cleaned out again, and reassembled. But n... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Thanks for the reply. That was the only way I could figure ... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I got it out. Filament was stuck at the bottom of the hot en... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Thank you for the reply. There are no chew marks on the fila... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Extruder not pulling filament Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
The oil seems to have done the trick. After two long failed ... Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
Thank you so much. I'm noting all of this. Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
Thank you so very much! I will try the oil right away. And I... Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
I printed the 8 inch tea cup in the attached photo with no t... Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
@tim-m30 Thank you for the reply. I found the settings. X = ... Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
I printed a small version of this Scrooge bust, but larger o... Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
I found it. Thank you very much! Dans le forum How do I print this? (Printing help) |
il y a 5 years |
|
Thank you! Do I need to add the supports in the drawing, or ... Dans le forum How do I print this? (Printing help) |
il y a 5 years |
