|
So after re-enabling the sensor, I print a smaller print and... In forum Hardware, firmware and software help |
4 years ago |
|
I tried turning off the filament sensor, just to see what wo... In forum Hardware, firmware and software help |
4 years ago |
|
@bobstro I'm on 3.9.0. I didn't think it would be the filame... In forum Hardware, firmware and software help |
4 years ago |
|
Fw glitch? In forum Hardware, firmware and software help |
4 years ago |
|
@robert-rmm200 It wasn't snagging on anything, at least noth... In forum Hardware, firmware and software help |
5 years ago |
|
@robert-rmm200 It wasn't snagging on anything, at least noth... In forum Hardware, firmware and software help |
5 years ago |
|
Edit: double checked the height, actually doesn't shift unti... In forum Hardware, firmware and software help |
5 years ago |
|
X axis shift at Height 48 In forum Hardware, firmware and software help |
5 years ago |
|
Tightened it about a full rotation, and it's kinda aggravati... In forum How do I print this? (Printing help) |
5 years ago |
|
I'll tighten it up some more then, but I'm still on the base... In forum How do I print this? (Printing help) |
5 years ago |
|
Odd missing bits? In forum How do I print this? (Printing help) |
5 years ago |
|
No haven't moved it or upgraded anything, apart from the fir... In forum Assembly and first prints troubleshooting |
6 years ago |
|
Advice needed In forum Assembly and first prints troubleshooting |
6 years ago |
