|
Yo may want to try some suggestiosn from this thread for so... In forum Hardware, firmware and software help |
12 months ago |
|
Mine looked exactly the same. What did help was the suggesti... In forum Assembly and first prints troubleshooting |
12 months ago |
|
Problem solved. The tweezer trick did the job. Thanks LilyPi... In forum Hardware, firmware and software help |
12 months ago |
|
I tried loosening the belt and also fastening the belt. Unfo... In forum Hardware, firmware and software help |
12 months ago |
|
Had a look on the bearings... positions seem ok to me. As me... In forum Hardware, firmware and software help |
12 months ago |
|
I had the same problem. Have you tried loosening the hot end... In forum Hardware, firmware and software help |
12 months ago |
|
20231126-104505_P9PkNdd0 Here's a video of the failed self t... In forum Hardware, firmware and software help |
1 year ago |
|
Thanks for your suggestions. Sadly neither belt tension (hig... In forum Hardware, firmware and software help |
1 year ago |
|
Hi, USB Stick neu formatieren oder anderen USB Stick schon p... In forum Hilfe zur Hardware, Firmware und Software |
1 year ago |
|
Same happened to me. Unfortunately I cannot get my printer t... In forum Hardware, firmware and software help |
1 year ago |
|
Same here. I am still on 5.0.1. and using prusa slicer 2.7.0... In forum Hardware, firmware and software help |
1 year ago |
|
y and z self test failure after update to 5.1.0 In forum Hardware, firmware and software help |
1 year ago |
|
Danke für den Tipp mit dem Lüfter. Ich habe festgestellt, da... In forum Hilfe zur Hardware, Firmware und Software |
1 year ago |
|
Habt ihr das Kontaktspray auf Boardseitig verwendet oder bei... In forum Hilfe zur Hardware, Firmware und Software |
1 year ago |
|
RE: Komische Geräusche Y-Achse und Hotendlüfter fail im Selb... In forum Hilfe zur Hardware, Firmware und Software |
1 year ago |
|
Komische Geräusche Y-Achse und Hotendlüfter fail im Selbstte... In forum Hilfe zur Hardware, Firmware und Software |
1 year ago |
