Prusa3D Forum

Notifications

Clear all

Dr. Mabuse

Skupina: Registrovaný

Přidal se: 2021/04/02

Active Member

	Dang, no replies after more than one year. Did you find bett... In forum How do I print this? (Printing help)	před 4 years
	Thank you! add extra layers if needed ON and detect thin wal... In forum How do I print this? (Printing help)	před 4 years
	Its 18.6mm high. Probably a configuration missmatch between ... In forum How do I print this? (Printing help)	před 4 years
	I did lay it down again and reduced the layer height to 0.15... In forum How do I print this? (Printing help)	před 4 years
	Thanks for the reply. There are 11 successfull prints (makes... In forum How do I print this? (Printing help)	před 4 years
	Sphere Lampshade Print (top fails) In forum How do I print this? (Printing help)	před 4 years
	Sphere Lampshade Print (top fails) In forum How do I print this? (Printing help)	před 4 years
	Davinci Kite from Thingiverse In forum How do I print this? (Printing help)	před 4 years
	And the problem/solution had been what exactly? In forum How do I print this? (Printing help)	před 4 years
	Printing a Print-Head / Printer Parts using ABS+? In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.8 K Příspěvky

10 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed